top of page

TPMS Sensor Repair Cleveland, OK

Helping You Drive Safely with Accurate Tire Pressure Monitoring

Ever see a little horseshoe-shaped warning light with an exclamation point pop up on your dash? That’s your TPMS (Tire Pressure Monitoring System) trying to tell you something—and at Bob’s Auto Repair, we’re here to help make sense of it and fix it when things go wrong.

 

What Is TPMS and Why It Matters

Your TPMS tracks your tire pressure and alerts you if it drops too low. It’s been required on most vehicles since 2008, and it's one of the easiest ways to catch a low tire before it turns into a real problem—like a blowout or uneven wear.

There are two types:

​

  • Direct TPMS uses pressure sensors inside each wheel.

  • Indirect TPMS uses the vehicle’s ABS system to detect pressure loss.
     

Both are helpful, but like anything electronic, they can go bad over time—and when they do, we can fix them.

 

Why You Shouldn’t Ignore the TPMS Light

Driving with low or high tire pressure puts unnecessary strain on your tires, engine, and brakes. It can lead to:

​

  • Faster tread wear

  • Poor gas mileage

  • Slower stopping

  • Increased chance of a blowout
     

The TPMS helps prevent that—but only if it’s working right.

 

Common TPMS Problems We Fix

​

  • Warning light stays on – usually just means a low tire, but we’ll check.

  • Light blinks or flashes – could be a sensor issue or battery failure.

  • Light comes on after adding air – may need a TPMS reset or sensor repair.

  • Sensors not responding – often means the battery in the sensor has died.
     

 

TPMS Sensors Don’t Last Forever

TPMS sensors are powered by small internal batteries. They usually last about 5 to 7 years, and once the battery dies, the whole sensor has to be replaced.

If your sensors are getting old and you’re buying new tires, we often recommend replacing the sensors at the same time to save time and labor costs later.

 

What We Do During a TPMS Service

At Bob’s Auto Repair, we’ll:

​

  • Check all your tire pressures

  • Inspect your tires for leaks or damage

  • Test each TPMS sensor for signal and battery life

  • Replace sensors if needed

  • Reset the system if the sensors or tires were rotated or changed

  • Replace valve stem seals and nuts if needed
     

We’ll also walk you through any issues we find and help you make the best decision for your vehicle and budget.

 

When to Reset Your TPMS

A TPMS reset is often needed:

​

  • After installing new tires

  • After rotating tires

  • After replacing a sensor

  • After fixing a flat
     

Some vehicles need a manual reset using a tool or a series of steps (like turning the ignition and pressing the brake). If you’re not sure how, we’ll take care of it for you.

 

Having TPMS Trouble? We’ve Got You Covered

Whether your light is on, blinking, or just acting weird—bring it in. We’ll get to the bottom of it. No guesswork, no upselling—just honest, reliable repairs.

At Bob’s Auto Repair in Cleveland, OK, we help local drivers stay safe, save money, and keep their vehicles running right.

Give us a call or stop by if you have questions about your TPMS. We’re happy to check it out and get you back on the road with peace of mind.

bottom of page